Copyright Partmaster Ltd 2010  The Partmaster range of Belts are manufactured for Partmaster Ltd by Toyopower, to exacting standards ensuring that they meet or exceed Original Equipment Manufacturer's specifications. The range stocked includes: Timing Belts (Cambelts) Cogged V Belts Multi-Rib Belts Serpentine Belts     MULTI-RIB & SERPENTINE BELTS Partmaster has more than 250 part numbers of Multi-Rib Belts covering most Multi pulley and serpentine engine drives. These belts were traditionally designed for small diameter pulleys. The Partmaster Multi-Rib Belts are available in very lengths and rib sizes.  The belts have a strong tensile member and are fibre reinforced which increases their resistance to wear and cracking, and provides about three times the traction area of a flat belt of equal width. This belt is thinner, giving flexibility, reducing internal heating. PARTMASTER COGGED V BELTS The Partmaster cogged V belt delivers maximum effiency on small sheaves, It's raw edge cogged narrow wedge construction is excellent for use with high speed application which are found on the modern motor vehicle. Like the Micro-V belts these are manufactured with fibre reinforcement  it will not shrink or stretch   TIMING BELTS Partmaster Timing Belts are made to meet or exceed tough OE performance specifications. Partmaster timing belts have high tensile strength cord construction, to minimize stretch, and a tough wear-resistant fabric on the working tooth surface. The belts resist oil and engine wear, and are designed to handle the wide speed ranges and constant positive drive power requirements common to overhead camshaft applications. All timing belts have the same warranty as the OE belt from the vehicle's manufacturer. DID YOU KNOW ? A screeching or squealing noise that occurs when pulling away from a stop normally indicates a lack of belt tension. Have a technician check the belts and don’t forget the tensioner.